Fostex VF160EX - Manual (Page 105)

105
Display in the audio CD playback mode
When switching to the audio CD playback mode, the display looks like the example below.
This section shows the current track number and name.
In this example, “CD01” shows the current track number
is “01”. On the right of the track number, the track name is
shown when playing back a CD TEXT disc (an audio CD
containing text information) which has track title
information. If the name is long and exceeds the display
area, it is scrolled in the next row.
When playing back a normal audio CD (which does not
contain text information) available on the market or burned
using the VF160EX, “No Title” is shown, as this example.
When an audio CD which has more than one track is set,
pressing the [REWIND/PREV] or [F FWD/NEXT] key while
holding down the [SHIFT] key locates to the beginning of
an appropriate track while the display shows “Locate:
EVT**”.
By pressing the [DISP SEL] key while holding down the [SHIFT] key, you can
switch the time base.
By pressing only the [DISP SEL] key, you can switch the display mode in the
current time base. See the table below for details.
In the audio CD playback mode, only the
level meters for tracks 1, 2 and L/R master
are effective. The playback level can be
controlled using the faders for tracks 1, 2
and [MASTER].
ABS
MTC (MIDI Time Code) is shown. It has an offset of 59 minutes 57 seconds to “ABS 0”
(the same offset as the internal HDD playback mode).
MTC
Track elapsed time is shown. Track time starts from the beginning of each track. Naturally,
at the point each track starts playback, the display shows “00m00s”.
OFFSET
Disc elapsed time is shown. The time starts from the beginning of a disc. The loop start
and end points refers to disc elapsed time.
When the current time base is ABS:
When the current time base is MTC:
When the current time base is OFFSET:
You can switch between “ABS”, “OFFSET” and “MTC IN”.
You can switch between “OFFSET” and “MTC IN”.
You can switch between “MTC”, “OFFSET” and “MTC IN”.
MTC IN: Show the MTC time input in the [MIDI IN] jack.
• Display mode selection in the current time base by the [DISP SEL] key
• Time base display mode selection by the [SHIFT] key and [DISP SEL] key