Fostex VF160EX - Manual (Page 111)

111
Flashing
Flashing
* If you load data to a program in which data is
already recorded, the newly loaded data overwrites
the current data track by track.
Consequently, on each overwritten track, the loaded
data becomes valid while the current data is erased.
5. Use the [JOG] dial to select the program to which data is
loaded and press the [ENTER/YES] key.
The display shows the screen for selecting tracks to be
loaded.
6. Select tracks to be loaded.
Press the [REWIND] or [F FWD] key to move the flashing
field between " From " and " To ".
Use the [JOG] dial to set the track number for the flashing
field. For the " From " field, you can select from 1, 9 and
17. For the " To " field, you can select from 8, 16 and 24.
For example, if you select "From 1 to 24", data for all
tracks (1 to 24) will be loaded.
7. After selecting tracks, press the [ENTER/YES] key again.
The display shows something like the one below. A load
destination program (existing or new program) to which
the data is loaded and tracks to be loaded are shown,
while "
Sure? " flashes.
<Note>
In the above step, if the VF160EX does not lock to the
digital signal from the external digital device, the
following warning message appears on the display.
This indicates that the VF160EX does not receive a
correct digital signal (S/PDIF or adat signal). So check
the cable connection and the digital output settings of
the external digital device.
8. When the VF160EX is locking to the digital input signal,
press the [ENTER/YES] key.
The display shows " Play Start Player! ".
9. Start playback of the player.
After reading the pilot signal recorded when saving the
data, the data starts loading automatically.
When starts loading, the display shows something like
the one below, in which "Wait time" starts counting down.
Using the " S/PDIF " signal, data is loaded in 2-track unit.
While loading, the indicators on [CH STATUS/CH SEL] keys
for channels 1 and 2 flash, while the input levels are
displayed by level meters 1 and 2.
Using the "
adat " signal, data is loaded in 8-track unit.
While loading, the indicators on [ CH STATUS/CH SEL] keys
for channels 1 through 8 flash, while the input levels are
displayed by level meters 1 and 8.
When the data loading is completed, "
Completed! " appears
on the screen.
<Note>
If you quit loading before completing, the loaded data
is invalid.
10. Stop the external DAT (or adat) machine.
11. Press the [EXIT/NO] key (or the [STOP] key) repeatedly
until exiting the Setup mode.
To cancel each operation or to return to the previous
screen before pressing the
[ENTER/YES] key, press the
[EXIT/NO] key (or the [STOP] key). Each press of the
key returns to the previous screen and finally exits
the Setup mode.
Flashing
4. Use the [REWIND] or [F FWD] key to select "SPDIF"
(or "adat") and press the [ENTER/YES] key.
The display shows the screen for selecting a load
destination program to which data is loaded.
A program number currently selected flashes, followed
by its program name. The data size of the current
program is also shown. When a program number is
flashing, you can select the desired load destination
program.
You can select a load destination program from existing
programs on the current drive as well as "
New PGM ".
When selecting " New PGM ", a new program is created.