Fostex VF160EX - Manual (Page 22)

22
Top Panel
Display Section
57. [ACCESS] LED
* This LED lights ON when the internal hard disk drive or
external SCSI device for backup purposes is writing or
reading data.
58. [PHANTOM] LED
* This lights ON when the phantom power is ON.
The phantom power is turned ON/OFF with the setup
mode.
59. LCD (Liquid Crystal Display)
* The recorder and mixer status and parameters are
shown on the LCD.
60. Contrast Adjusting Knob
* This is used to adjust the contrast (difference in
brightness) of the LCD. Increase or decrease the contrast
by turning it clockwise or counterclockwise,
respectively.
Rear Panel
ACCESS
PHANTOM
59
60
58
57
2 1 R L
IN OUT
IN OUT
AVIS:
OPTICAL
AC-IN POWER FOOT SW DIGITAL/DATA MIDI ST OUT AUX SEND
CAUTION
RISK OF ELECTRIC SHOCK DO NOT OPEN
RISQUE DE CHOC ELECTRIQUE NE PAS OUVRIR
WARNING:
TO REDUCE THE RISK OF FIRE OR ELECTRIC
SHOCK, DO NOT EXPOSE THIS EQUIPMENT
TO RAIN OR MOISTURE.
61 62 63 64 65 66 67 68 69
TIP:
AUX1
To Effect 1
To Effect 2
RING:
AUX2
GND
62. [ST OUT-L/R] Jack
* Master recorders and other devices are connected to
output stereo L/R signals.
* Standard Output Level: -10dBV
* Connector: RCA (pin)
63. [MIDI IN] Jack
* Connect to the MIDI OUT jack of an external MIDI
device.
61. [AUX SEND-1/2] Jack
* External effector or other devices are connected to
output the AUX SEND 1/2 signals.
* Standard Output Level: -10dBV
* Use a Y-cable, as shown below, to connect an external
effector since the ø6 TRS Phones jack is used.
* MIDI control signals such as MMC (MIDI Machine
Control) is mainly input.
* Connector: DIN 5 PIN
64. [MIDI OUT] Jack
* Connect to the MIDI IN jack of an external MIDI device.
* MIDI synchronization signals such as MTC (MIDI Time
Code) and MIDI clock signals & song position pointers
are mainly output.
* Connector: DIN 5 PIN
65. [DIGITAL/DATA IN] Jack
* Connect to OPTICAL DIGITAL OUT (S/P DIF) or adat
DIGITAL OUT of an external digital device for signal
input to the VF160EX.
* This is used to load DAT/adat song data.
* Connector: Square optical
66. [DIGITAL/DATA OUT] Jack
* Connect to OPTICAL DIGITAL IN (S/P DIF) or adat
DIGITAL IN of an external digital device for signal
output from the VF160EX.
* This is used to save DAT/adat song data.
* Connector: Square optical
67. [FOOT SW] Jack
* Punch IN/OUT option by connecting the Fostex Model
8051 foot switch (unlatched type).
68. [POWER] switch
* This turns ON/OFF the power of the VF160EX.
69. [AC IN] Jack
* This is where the accessory power cable is inserted.
For more details, refer to the respective instructions of
each item.
70
Front Panel
70. CD-R/RW drive
* After turning the power on, pressing the eject key in the
front of the drive opens the tray. To close the tray, push
the front of the tray lightly by your hand.
Using the CD-R/RW drive, you can also save/load song data
to/from a CD-R or CD-RW disc, or burn an original audio
CD.