Fostex VF160EX - Manual (Page 97)

97
Making the chain play list
Before executing chain play, you must make the chain
play list by selecting the desired (or all) programs in
the desired order. You can enter up to 99 programs
to the chain play list.
On pages 98 and 99, two procedure examples for
entering programs on the VF160EX current drive to
the list are shown. The former example shows how to
enter all programs on the current drive, while the
latter shows how to enter desired programs. Both
examples assume that 10 programs exist on the
current drive.
1. While the VF160EX is stopped, press the [SETUP] key.
The VF160EX enters the setup mode and the display
changes to show the “Select Menu” screen for selecting
a setup menu item. By default, the “Signature Set” flashes
as shown in the figure below.
2. Use the [JOG] dial to select “Chain Play List” which is
the 23rd menu item (R23) in the setup menu, and then
press the [ENTER/YES] key.
The display changes to show the “Chain Play List” screen,
in which “C01:END” is highlighted by default. “C01”
shows the step number, while “END” shows no program
is entered to the chain play list.
3. Press the [ENTER/YES] key again.
“END” starts flashing and you can now enter a desired
program to step 01.
By rotating the [JOG] dial while “END” is flashing, you
can select a desired option from among the programs
on the drive (“P01” through “P10”), as well as “ALL”,
“INS” and “DEL”. See the table below for details about
each option.
END
The current and succeeding steps in the chain play
list are all deleted. (See “Deleting all programs from
the chain play list” described later for details.)
ALL
All programs on the current drive are entered to the
chain play list. Note that you can select “ALL” to step
1 (C01) only. There is no “ALL” option on other steps.
(See “Making the chain play list by selecting all the
programs” described later for details.)
INS
A desired program can be added (inserted) to the
current step. (See “Inserting a program to the chain
play list” described later for details.)
DEL
The program on the current step is deleted. (See
“Deleting a program from the chain play list”
described later for details.)
P01
~
Pnn
A desired program is entered to the current step. If
another program is already entered, the new
program overwrites it. You can select any of the
programs on the current drive. (See “Making the
chain play list by selecting desired programs”
described later for details.)
Making the chain play list by selecting all the programs
The following procedure example shows how to enter
all the programs (P01 through P10) on the current
drive to the chain play list.
1. While “END” is flashing, rotate the [JOG] dial to select
“ALL”, and press the [ENTER/YES] key.
By rotating the [JOG] dial to the left, you can find “ALL”
easily.
By pressing the [ENTER/YES] key after selecting “ALL”,
all programs on the current drive are entered to the chain
play list, as shown in the screen example below.
By rotating the [JOG] dial, you can scroll through the list
to check the chain play list. In the last line on the list,
“C11: END” is shown, which shows that no more program
is entered after step 11.