Fostex VF160EX - Manual (Page 145)

145
2. Input the desired item with the [JOG] dial and press the
[ENTER/YES] key.
The selected item will be set.
In the "Setup of the fader recall mode" menu, whether each channel input fader/master fader settings should be
recalled or not at scene recall, can be setup.
1. Select “Fader Recall” in the menu a selection display and
press the [ENTER/YES] key.
The currently set will flash. “ Off ” will flash in the initial
setting.
Off When scene is recalled, the fader
(Initial setting) position immediately prior to
recalling the scene will be directly
employed without recalling the
setup figures of each channel fader
and the master fader.
CH (Channel) When scene is recalled, setup figures
of each channel faders only will be
recalled and not recall the master
fader setup figure.
MST (Master) When scene is recalled, the setup
figure of the master fader only is
recalled and the channel fader setup
figures will not be recalled.
CH & MST When scene is recalled, each
channel faders and the master fader
set up figures will both be recalled.
3. Press the [EXIT/NO] key (or [STOP] key) to exit from the
SETUP mode.
• Initial setting: “Off”
• Options: “Off”, “CH”, “MST” or “CH & MST”
* You can set the value for each Program individually.
* The settings can be saved and loaded as part of the
song data.
* The settings are maintained after you turn off the
power to the VF160EX.
Flashing
<Caution>
When changing the setting from any option other than "Off" to "Off", or from "CH&MST" to "MST" or "CH", "Level Adjust!
Sure?" appears in the display (this is because, after a scene is recalled, the physical fader positions may not match the
levels). Press the [ENTER/YES] key and adjust levels. Note that there may be sudden level jumps depending on the fader
positions. If you do not adjust levels, press the [EXIT/NO] key.
Fader Recall Mode Setting [“Fader Recall”]