Fostex VF160EX - Manual (Page 131)

131
<Hint>
If you are going to load tracks 1 and 3 in the example
above, instead of tracks 1 and 2, track 3 will be loaded
to program 06 (see the screen example below).
However, if you select track 2 after selecting tracks 1
and 3, the unit automatically reassigns track 2 to pro-
gram 06 and track 3 to program 07 (see the screen
example below).
14. Press the [EXIT/NO] key to exit the setup mode.
On the contrary, when you set the load type to “Select”,
the load destination program number for the secondly
selected track is same as the firstly selected track. That
is, all selected tracks are loaded to the same program.
11. Press the [ENTER/YES] key.
As with the firstly selected track, the secondly selected
track (“02”, in this example) is set.
12. Operate the same procedure as above for selecting other
tracks.
13. When completing selecting all desired tracks, press the
[ENTER/YES] key while holding down the [RECORD] key.
The display shows “Data Loading!” while the remaining
data amount (in MB) is counted down. You cannot cancel
loading once it starts. Wait for a while until loading is
completed. Loading more amount takes more time.
When completing loading, “Load Completed!” is shown,
while the audio CD is automatically ejected from the CD-
R/RW drive.
<Hint>
To play back a desired loaded track on the current drive,
carry out the following operation depending on the load
type.
• To play back a track loaded with the type set to “One”:
1. Select the appropriate program to which the track
to be played back is loaded by following the
procedure below.
See “Selecting a program” on page 71 of the
owner’s manual for details about how to select a
program.
1-1. Press the [PGM SEL] key.
1-2. Use the [JOG] dial to highlight the appropriate
program.
1-3. Press the [ENTER/YES] key.
2. Press the [PLAY] key to start playback of the track.
• To play back tracks loaded with the type set to “Select”
or “All”:
1. Select the destination program by following the
same procedure as step 1 above.
2. Select a desired track in the program by pressing
the [REWIND/PREV] or [F FWD/NEXT] keys while
holding down the [SHIFT] key when the recorder
is stopped or during playback.
Because all the tracks loaded take part in the same
program, you have to select a track within the
program.
The VF160EX automatically set an event at the
beginning of each track loaded with the type set
to “Select” or “All”, so pressing [REWIND/PREV]
or [F FWD/NEXT] key while holding down the
[SHIFT] key locates to the beginning of the previous
or next track, as with a typical CD player on the
market (see “Event function” on page 36).
3. Press the [PLAY] key to start playback of the track.
To check events, press the [SCENE STORE/MAP] key
while holding down the [SHIFT] key while the
recorder is stopped. The display shows the event
map, allowing you to check the event positions (in
the screen example below, the time base is set to
“Bar/Beat/Clk”).