Fostex VF160EX - Manual (Page 30)

30
Switching with [DISP SEL] Key
Every time the [DISP SEL] key is pressed the LCD
alternately shows the “ 1. Normal Display of Current Time
Base ” -> “ 2. REMAIN Display of Current Time Base ” -> “ 3.
MTC Time Display Input ”. The description of each display
is defined below.
1. Normal Display of Current Time Base
* Current time according to current time base.
* Program number and program title.
The first 9 characters of the program title are shown.
* Scene number and scene name.
The first 9 characters of the scene name are shown.
* Level meter of tracks 1 to 16.
* L/R master level meter
2. REMAIN Display of Current Time Base
* REMAIN time and space available in mono-track
converted units according to the current time base (the
following is the case in ABS).*1
* Format type.
* Name of hard disk.
* Level meter of tracks 1 to 16.
* L/R master level meter.
3. MTC Time Display Input
* MTC time input.
“00H 00M 00S 00F” appears if there is no time input.
* Program number and program title.
The first 16 characters of the program title are shown.
* Scene number and scene name.
The first 16 characters of the scene name are shown.
* Level meter of tracks 1 to 16.
* L/R master level meter.
*1. The REMAINING time display appears as follows
according to the time base that has been selected.
Time Base: ABS and MTC
Time Base: BAR/BEAT/CLK
*2. Icons of the program setup details appear at the
right side of the menu. Refer to examples below.
This indicates recording/no recording
setup by the “Rec Protect” menu. The
icon shown here is indicating that it is
presently set “Off” and thus recording is
possible.
This is indicating the VF160EX sampling
frequency (Fixed to 44.1kHz).
The icon here is indicating that the current
drive is set to an “E-IDE hard disk.”
This indicates the MIDI sync output signal
setup by the “Midi Sync Out” menu. The
icon here is indicating that it is presently
set to “CLK.”
This indicates the slave type setup by the
“Slave Type” menu.
This icon is indicating that it is presently
set to “VARI.”
Frame rate figure setup by the “MTC
Frame Rate” menu is indicated here.
The icon here is indicating that it is
presently set to “25 Frames.”