Fostex VF160EX - Manual (Page 25)

25
1. Unscrew the four screws fixing the panel to the
bottom of the VF160EX main unit.
If the panel is removed, the hard disk covered with a
cushion can be seen.
2. Take out the hard disk to the direction “2” indicated
in the drawing below.
Slightly lifting up the cushion upward helps you take out
the hard disk easily.
When taking it out, do not apply excessive force.
3. Hold the connector section and gently pull out the
two cable connectors from the hard disk.
5. Put back the new hard disk into the VF160EX main
unit.
In the reverse order of taking out the hard disk as
performed earlier, carefully house the hard disk at the
bottom of the main unit and cover it with the cushion.
6. After checking that the cables, etc. are not sticking
out from the main unit, put the panel onto the hard
disk and the case.
Align the position of screw holes on the panel / case with
the VF160EX bottom panel screw holes and fix the panel /
case using the four screws to the VF160EX main unit.
When the new hard disk is successfully assembled, go
to the next section. Now, format the unformatted hard
disk.
1
2
4. Prepare a new hard disk and connect the two cable
connectors to it with holding the connector section.
Cushion
Cushion
Hard disk unit
Hard disk unit
Connector
Hard disk unit
Connector
Hard disk unit
Bottom
Panel
2
1
Cushion
Connector
1
4 3
2