Fostex VF160EX - Manual (Page 116)

116
When completing the save operation, “Save Completed!”
appears on the display (as shown below) and the VF160EX
stops access to the drive, while the disc in the CD-R/RW
drive is automatically ejected.
<About save error>
If an error occurs for some reason during the save
operation, the error message as below appears.
If it appears, press the
[EXIT/NO] key.
The display returns to the previous screen before
performing the save operation.
Note that saved data before the error message ap-
pears is all invalid.
<Note for saving data to more than one disc>
If you save data to more than one disc, we recom-
mend to put a number on each disc in the saving
order (such as
DISC-1 , DISC-2 , etc.) so that you will
easily know the order for inserting discs when load-
ing data.
<Note>
You cannot abort the save operation before com-
pleted. Especially during the save operation to more
than one disc, if you happen to press the
[EXIT/NO]
key while removing or inserting a disc, you have to
redo the save operation from the beginning with the
first disc.
<Note>
If the message above appears while saving data
to a
CD-R disc, you can no longer use the disc.
8. Press the [EXIT/NO] key (or the [STOP] key) to exit the
Setup mode.
When saving data to more than one disc, the first disc
will be ejected when it is full (i.e. there is no more re-
cording space on the disc), while
“Insert Disk!” appears
on the screen. After inserting the second disc, the
VF160EX automatically resumes the save operation.
After completing the save operation, the final disc is
ejected and the above screen appears. (See
<Note> be-
low).
<Hint 1>
In the description for saving data above, we assume to
use a non-recorded CD-RW/CD-R disc.
If you use a recorded disc (including a disc on which
computer data is recorded), also note the following.
By performing step 5 in the save operation procedure
shown above (“While
“BkUp” is flashing, press the [EN-
TER/YES] key”.) When a recorded disc is inserted, the dis-
play shows a warning message, followed by the confir-
mation screen (where
“Sure?” flashes).
With this screen, you can choose whether erasing the re-
corded data or ejecting the disc.
• To erase the existing (recorded) data
Press the [ENTER/YES] key while both “ERASE” and
“Sure?” are flashing. The display shows the screen be-
low and the VF160EX starts erasing the disc.
As the erase process progresses, the number of flashing
“*” increases from left to right.
Immediately after completing erasing the disc, the
display shows the same screen (for selecting a pro-
gram to be saved) which appears after step 5 is
performed. Hereafter, perform the same procedure
as described above.
Increases as the process progresses.
Flashing Flashing
<Note>
The erasure operation described above is the "quick
erasure". The VF160EX only erases special areas (TOC,
etc.) and does not erase data area. If you repeatedly
encounter a read error after carrying out the erasure
operation above, try to carry out "full erasure" de-
scribed on the next page.
<Hint 2>
If you try to save data to a recorded CD-R disc, the dis-
play shows a warning message saying “Not Writable” , fol-
lowed by a message saying “Insert Disk” as below.
• To eject the disc
Use the [JOG] dial to highlight “Eject” (flashing) and press
the [ENTER/YES] key.
The disc is ejected while the display shows “Insert Disk! ”.
By inserting a disc, you can start the save operation
again from the beginning.