Fostex VF160EX - Manual (Page 24)

24
5. Press the [ENTER/YES] key while the [RECORD]
key is depressed.
If the “Standard” format is selected and executed, the
formatting process takes place while showing the progress
of the good sectors (Good ***MB) on the disk, bad sectors
on the disk (Bad ***MB) and remainder (Remain ***MB).
Nothing can be done during the formatting process.
Please wait for a while until the process is completed.
6. Press the [EXIT/NO] key (or [STOP] key) to escape
from the SETUP mode.
The Normal Display appears indicating the beginning of
the program (P01) that is automatically created after
formatting the hard disk.
When the hard disk is successfully formatted (formatting
completed), the number of sectors and noncontiguous
sectors are shown after formatted, then
“Completed!”
lights up. Formatting is completed instantaneously if
either
“Erase” or “Quick” is selected and executed.
For this reason, the “Completed!” message lights up
without showing the progress status while formatting is
taking place.
Replacing a hard disk
<Warning>
This section describes the procedures to replace the hard disk. However, we recommended that the customer
ask the Fostex Customer Service Department to replace the VF160EX hard disk. Note that the product is not
warranted for any malfunctions that may occur after the customer replaces the hard disk on their own. Also
note that Fostex will not be held liable for any accidents that may occur during the replacement process or
any hard disk damages, if the customer decides to replace their own hard disk on their own.
<Operation Confirmed HD & Backup Media List for the VF160EX>
The updated information on the operation-confirmed HD and backup media for VF160EX is mentioned in
the following Fostex international web site.
<http: // www. fostex.co.jp/int/index.htm>
For those who are unable to check our web site, please contact the Fostex distributor in your territory.
<Precautions Upon Replacement>
* Always turn OFF the power of the VF160EX and unplug the power plug from the electric outlet when replacing the hard
disk.
* Always place the hard disk on a flat and stable platform during the replacement process. Place a soft cloth under the
unit to protect the product from scratching. Gloves are recommended to prevent any hand injuries.
<Precautions Upon Handling the Hard Disk>
* A hard disk is an extremely sensitive precision device. Never expose the hard disk to “strong shocks” when replacing,
assembling or handling. Never leave the hard disk by a device that generates strong magnetic fields.
* Always set the DIP switch and Jumper of the newly assembled hard disk to the [Cable Select] setting. The hard disk will
not operate normally if the setting is set to [MASTER] or [SLAVE] when the hard disk is assembled. Refer to the User’s
Manual of the hard disk for more details on the DIP switch and Jumper settings.
* Note that the connector of some hard disks may be stiff, and thus make it difficult or impossible to insert or connect.
Never apply excessive force to insert the connector in such case. Always make a point to gently insert the connector.
Failure to do so may result in unexpected injuries or damage the hard disk.