Fostex VF160EX - Manual (Page 119)

119
When completing the load operation, “Load Completed!”
appears on the display (as shown below) and the VF160EX
stops access to the drive, while the disc in the CD-R/RW
drive is automatically ejected.
8. Press the [EXIT/NO] key (or the [STOP] key) to exit the
Setup mode.
<Note>
If there is not enough available space for loading on
the current drive, the display shows “
Disk Full! ” and
the display returns to the previous screen.
<Note>
You cannot abort the load operation before completed.
When loading data from more than one disc, the first
disc will be ejected immediately after all disc data has
been loaded, while
“Insert Disk!” appears on the screen.
After inserting the second disc, the VF160EX automati-
cally resumes the load operation.
After completing loading all the discs, the above screen
appears.
<About load error>
If an error occur for some reason during the load
operation, the error message as below appears.
If it appears, press the
[EXIT/NO] key.
The display returns to the previous screen before per-
forming the load operation.
Note that loaded data before the error message ap-
pears is all invalid.
7. While “New PGM” is shown, press the [ENTER/YES] key.
The VF160EX starts the load operation. The recorded
space shown on the display is counted down while the
load operation progresses.
It will take some time for loading all data. The following
display example shows that the data of the backup
number “
B01 ” is being loaded to “ P08 ” which is newly
created on the current drive.
<Display example for loading>