Fostex VF160EX - Manual (Page 102)

102
Inserting a program to the chain play list
You can insert a program to a desired step in the
current chain play list.
1. Follow procedure steps 1) and 2) on page 100 to show
the “Chain Play List” screen.
(i.e. enter the setup mode and select “Chain Play List”.)
2. Use the [JOG] dial to select a step where you want to
add a program and press the [ENTER/YES] key.
The program number set to the selected step starts
flashing. If you select “C02” on the left screen example
below, “P02” starts flashing.
3. Use the [JOG] dial to select “INS” and press the [ENTER/
YES] key.
You can now select a program to be inserted. Initially,
“P01” flashes. As you can see by comparing the two
screen examples above, the programs set to the second
and subsequent steps slide down automatically.
4. Use the [JOG] dial to select a program to be inserted,
and press the [ENTER/YES] key.
In the example shown below, program 6 (P06) is inserted
to step 2.
5. After inserting all desired programs, press the [EXIT/NO]
key.
The “Chain Play List” screen is dismissed and the display
returns to the “Select Menu” screen where the current
option of the “Chain Play” mode setting is flashing.
If you want to insert a program to another step, repeat
the same procedure above.
<Note>
If you insert the desired program(s) to the chain
play list when the “Chain Play” mode is set to any
option but “Off”, the “Chain Play” setting
automatically changes to “Off” (the default).
Therefore, to execute chain play after editing the
chain play list, you must set the “Chain Play” mode
appropriately again.
6. After setting the “Chain Play” mode appropriately, press
the [EXIT/NO] key repeatedly until exiting the setup
mode.
<Note>
You can enter up to 99 programs to the play list. If
you are trying to enter a program to the play list
where 99 programs are already registered, “Void!
Play List is Full” is shown and the operation is
canceled.