GE 68K System - Manual (Page 41)

68K System Monitor
User's Guide
GE Energy Services
General SWM0023-1.00 -2
Full Release 3-15
CF - Copy File
Platform o CPM o D20
D20 Base o D20 ME
D20 Base þ D20/200
CCU Base o D20/200 ME
CCU Base þ D25
Description Use this command to copy file information from one file to another.
Primarily, use the command to transfer files containing configuration, application
FLASH and DSP FLASH program data into their destination regions.
Also, use it to copy any one file to another, depending on the support for copying
provided by the File System Driver that owns the files.
Syntax Below is usage and syntax information for this command
Command Format cf source_file [destination_file]
Variables None
Parameters source_file = The name of the file containing the source
data. This is always required, and is the full
path name of the file. If the operation is
transferring configuration or FLASH program
information (DSP or application), then only
the source name is required.
destination_file
= The name of the file into which the source file
data is to be copied. If you intend to copy
configuration or FLASH program
information (DSP or application) into its
destination region, this name is optional and
unnecessary
Example Type cf flash.zlb and press ENTER .
Results: The monitor copies the file flash.zlb into Flash
EPROM.
Special
Considerations Once invoking this function, it may take some time for the
command to write the file into its destination; especially if it
consists of compressed configuration or FLASH program
information (DSP or application).