GE 68K System - Manual (Page 82)

GE Energy Services
68K System Monitor
User's Guide
SWM0023 1.00 2 General
3-56 Full Release
RB - Resume Breakpoint
Platform þ CPM þ D20
D20 Base o D20 ME
D20 Base o D20/200
CCU Base þ D20/200 ME
CCU Base þ D25
Description Use this command to restart a process that stopped at a breakpoint, without removing
the breakpoint.
It verifies the specified breakpoint, restarts the associated process, and then reinserts
the breakpoint trap.
Syntax Below is usage and syntax information for this command
Command Format rb break_pt# [#reps]
Variables None
Parameters break_pt# = breakpoint number as returned with the define
breakpoint command.
#reps = number of times (in decimal) to repeat
execution of the breakpoint address before
stopping; default is zero.
Example Type rb 1 and press ENTER .
This resumes breakpoint number one (1) that stops again
before the second execution of the instruction at the breakpoint
address.
Results: The system responds with the prompt. Whenever it
encounters a breakpoint, the system displays the
breakpoint number, loop count, and register values.
If the loop count is greater than zero, it is
decremented. Otherwise, the process is suspended.
Special
Considerations None