GE 68K System - Manual (Page 83)

68K System Monitor
User's Guide
GE Energy Services
General SWM0023-1.00 -2
Full Release 3-57
RP - Resume Process
Platform þ CPM þ D20
D20 Base þ D20 ME
D20 Base þ D20/200
CCU Base þ D20/200 ME
CCU Base þ D25
Description Use this command to restart all processes, some processes, or a specific suspended
process.
Use this command to restart processes that have been suspended using the suspend
process (SP) command.
Syntax Below is usage and syntax information for this command
Command Format CPM / D20 / D25: rp [(pid | name)]
CCU / CCUME: rp [(pid | gpid | name)]
Variables None
Parameters (none) = resume all processes.
pid = pSOS process ID (in hexadecimal); resume a
specific process.
gpid = global pSOS process ID (in hexadecimal);
resume a specific process
name = case-sensitive process name. The monitor
supports the new process naming convention.
If you enter an entire name, the monitor resumes
the specified process.
If you enter the first few characters, the
command attempts pattern matching. The
monitor will then resume all matching processes.
Example Type rp and press ENTER .
This enables all suspended processes to resume execution.
Results: Unless it encounters an error, the system displays the
prompt. If it encounters an error, the system displays
an error message before it returns to the prompt.
Special
Considerations Do not use this command to start a D25 after an NVRAM
download or after an error caused it to halt.
In these cases, you must reboot the D25 to ensure that all
parameters and variables are re-initialized properly.