GE 68K System - Manual (Page 66)

GE Energy Services
68K System Monitor
User's Guide
SWM0023 1.00 2 General
3-40 Full Release
HT - HDLC Test
Platform o CPM þ D20
D20 Base þ D20 ME
D20 Base o D20/200
CCU Base þ D20/200 ME
CCU Base o D25
Description Use this command to transmit specific application messages over the HDLC
communication link.
Note:
Because you must assemble these messages by hand, you can not use the
command effectively unless you know the protocol used by the D.20
application.
Syntax Below is usage and syntax information for this command
Command Format ht /(c | m | r | s | w)
Variables /c = configure the link parameters
/m = define the application message
/r = read (monitor) the link
/s = display configuration status
/w = send an application message
Parameters None
Example None required
Special
Considerations This command is not available on the CPM.
This command is not available if the D.20 (B003) application
is active.