Garland JACK IN THE BOX XG36-JIB - Manual (Page 11)

Part # JIBSM08 Rev.6 (08/04/09) Page 11
UNIT INSTALLATION
continued
B. Install the nipple assembly into the elbow (3/4” NPT)
Refer to Photo A
C. Install the manifold support bracket over the nipple
attaching it to the circular bracket on the nipple. Do not
tighten screws. Refer to Photo B
Photo B
D. Adjust the manifold support bracket flush with the rear
gas support bracket. Refer to Photo B
E. Tighten the loose screws of the manifold support bracket.
Refer to Photo B
F. Lock the two brackets together using two screws. Refer to
Photo C
Photo C
Accessory Kit – Electrical Supply Lines:
The accessory kit also contains electric power cord and
plug and has a stain relief suited for each unit. Refer to Plug
Configuration in SPECIFICATIONS and Photo D
Installation of Cord And Plug With Strain Relief:
1. Remove the left grease bucket support attached by two
metal screws and the stainless steel left side body panel
attached by five metal screws.
2. Remove the cord & plug and strain relief assembly from
the accessory kit. Refer to photo D.
Photo D
3. Remove the locknut from at the end of the cord. Refer to
photo E.
Photo E