Normal operation – Garland JACK IN THE BOX XG36-JIB User Manual

Page 20

Advertising
background image

Part # JIBSM08 Rev 7 (08/04/09)

Page 20

2. The controller regulates the platen and grill temperatures

to the set temperatures of the product selected and

reads “TOO COOL” or “TOO HOT” with “MENU ITEM”, until

the grill attains the set temperature range for the item.

NOTE: If the display reads either “TOO COOL” or “TOO HOT”

the upper platen will not lower and initiate a cooking

sequence.

3 After loading the product onto the grill, press the green

CANCEL/RAISE PLATEN BUTTON and BLACK button

simultaneously. A cook cycle starts and the upper platen

lowers if the product selected is clamshell recipe.

4 To cancel a cook cycle at anytime press the green

CANCEL/RAISE PLATEN BUTTON and the upper platen

will rise if the product recipe selected is clamshell recipe.

5. During a cook cycle, the display shows the product recipe

name in the first line and the remaining cook time count

down in the second line.

6 When the cook timer reaches one, (1), second remaining

a pre-time-out alarm sounds alerting the operator.

7 When the cooking time has been completed the platen

raises automatically. On the controller the “PRODUCT

NAME” and the word “REMOVE” will be displayed and an

audible alert will sound.

8. Pressing the green CANCEL/RAISE PLATEN BUTTON stops

the audible alert and the unit will revert back to IDLE

mode.

To Cook in Flat Grill Mode:

1. To start a cook cycle select a product recipe by using the

product keys (1 through 9) or by using the UP/DOWN

keys or to select a product recipe.

The display alternately blinks the recipe and the word

SELECTED 2 times then the recipe will be displayed

continuously.

2. The controller regulates the grill temperature to the set

temperature of the product selected and reads “TOO

COOL” or “TOO HOT” with “MENU ITEM”, until the grill

attains the set temperature range for the item.

NOTE: If the display reads either “TOO COOL” or “TOO HOT” it

will not initiate a cooking sequence.

3 After loading the product onto the grill, press the green

CANCEL/RAISE PLATEN BUTTON and BLACK button

simultaneously. That will start a cook cycle if the product

selected is clamshell recipe.

NORMAL OPERATION

Installing Release Material:

For installation instructions, see section on RELEASE

MATERIAL INSTALLATION.

A release material sheet must be replaced when:

• Product sticks to release material.

• Carbon build-up ruins taste or appearance.

• Tearing occurs in the sheet’s cooking area.

• Release material coating is worn off sheet.

Lighting Instructions:

1. Ensure that the flexible gas hose is connected to the grill

and the power cord is plugged into the receptacles.

2. Turn the main power switch ON and allow the controls

to go through the power-up self-check. Once the control

panel displays the word “OFF” the unit is ready to begin

the heating process.

3. Press . The control will automatically initiate the

heating cycle. The burner will ignite and heat until the

temperature specified by the menu item has been

obtained.

If ignition of the burner does not occur on the first trial, the

bottom indicator light will flash amber. If the burner(s) do

not light within four trials for ignition, the control will display

a flashing warning, “IGNITION ERROR.” The flashing amber

light will turn to solid red and an audible alarm will sound. If

this occurs, turn the main power switch off, wait 5 minutes,

and then repeat steps 2 and 3. If after 2nd try and the control

still produces the IGNITION ERROR refer to Ignition failure in

TECHNICAL TROUBLE SHOOTING section.

Shut Down Instructions

1. To shut down the unit at any time, switch the main power

switch to the off (non-lit) position.

2. For extended shut down periods, switch the main power

switch to the off position, disconnect the unit from the

gas supply line and unplug electrical connections.

To Cook in Two-Sided Mode:

1. To start a cook cycle select a product recipe by using the

product keys (1 through 9) or by using the UP/DOWN

keys or to select a product recipe.

The display alternately blinks the recipe and the word

SELECTED 2 times then the recipe displays continuously.

Advertising
This manual is related to the following products: