Garland JACK IN THE BOX XG36-JIB - Manual (Page 7)

Part # JIBSM08 Rev.6 (08/04/09) Page 7
SAFETY
Always follow these safety precautions when operating the
Xpress Grill.
• THIS GRILL MUST be operated by persons who have
been given adequate training.
• THIS EQUIPMENT MUST ONLY BE OPERATED UNDER AN
APPROVED HOOD SYSTEM .
• DO NOT OPERATE THE GRILL UNLESS IT HAS
BEEN COMMISSIONED (START-UP) BY A FACTORY
AUTHORIZED SERVICE CENTER .
• DO NOT operate the grill without reading the operation
manual.
• DO NOT operate the Xpress grill unless it has been
properly installed and grounded.
• DO NOT operate the Xpress grill unless all service and
access panels are in place and fastened properly.
The Garland Xpress Grill is a semi-automatic cooking
appliance. The upper platen is lowered automatically,
following the manual, two-handed initiation of the cooking
cycle, and the upper platen is raised automatically upon
completion of the cooking cycle.
INTRODUCTION
The Garland Xpress grill, for Jack in the Box provides
a method for efficient two-sided cooking, while
accommodating a variety of products. The unit will also serve
as a flat grill, and meets all of Jack in the Box’s standards for
safety, efficiency, and cleanliness.
Warranty
This warranty covers defects in material and workmanship
under normal use providing that:
a) The equipment has not been accidentally or intentionally
damaged, altered or misused.
b) The equipment is properly installed, adjusted, operated
and maintained in accordance with national and local
codes and in accordance with the installation instructions
provided with this product.
c) The warranty serial number affixed to the appliance by
Garland has not been defaced, obliterated or removed.
d) An acceptable report for any claim under this warranty is
supplied to Garland.
The equipment warranty coverage remains in force for one
(1) year (parts and labor) from the date the equipment is put
into operation.
The Garland Group agrees to repair or replace, at it’s
option, any part that proves to be defective in material or
workmanship at no charge for the part or normal labor.
We assume no responsibility for installation, adjustments,
diagnosis, or normal maintenance such as: lubrication of
springs or valves. We exclude failures caused by erratic
voltage or gas supplies. We assume no responsibility for
travel costs beyond 100 miles round trip, travel other
than overland, and overtime costs of repair. We exclude
broken glass, paint and porcelain finish, surface rust, gasket
material, ceramic material, light bulbs and fuses from normal
coverage. We exclude damage or dysfunction caused by fire,
flood, and like “Acts of God” that are beyond the control of
The Garland Group.
The Garland Group’s liability on a claim of warranty shall
not exceed the price of the material and/or service, which
caused the claim. This warranty is limited and is in lieu of all
other warranties, expressed or implied. The Garland Group,
our employees, or our agents shall not be held liable for any
claims of personal injury or consequential damage or loss.
This warranty gives you specific legal rights, and you may
have other rights which vary from state to state.
Shipping Damage Claim Procedure
Please note that the Garland equipment was carefully
inspected and packed by skilled personnel before leaving
the factory. The transportation company assumes full
responsibility for safe delivery upon acceptance of the
equipment.
What to do if the equipment arrives damaged:
1. File a claim immediately regardless of the extent of
damage.
2. Be sure to note, "visible loss or damage," on the freight
bill or express receipt and have the person making the
delivery sign it.
3. Concealed loss or damage: if damage is unnoticed until
the equipment is unpacked, notify the freight company
immediately, (within 15 days), and file a concealed
damage claim.