Garland JACK IN THE BOX XG36-JIB - Manual (Page 31)

Part # JIBSM08 Rev.6 (08/04/09) Page 31
To Change the Grill Function:
1. Press and hold for three, (3) seconds. “ENTER CODE” is
displayed.
2. Using the Product buttons, 0-9 enter the code, (1251).
“ENTER CODE **** ” is displayed.
3. Press to enter the Programming Mode.
“PROGRAMMING MODE MENU ITEMS” is displayed.
4. Press two, (2) times. “PROGRAMMING MODE SYSTEM
SETUP” is displayed.
5. Press eleven, (11) times. “FUNCTION CLAMSHELL (or
FLAT)” is displayed.
6. Use and to toggle between Flat mode and
Clamshell mode.
7. Press to save the changes.
8. Press to return to “PROGRAMMING MODE MENU
ITEMS”
9. Press again to exit.
To Change the Start Delay:
1. Press and hold for three, (3) seconds. “ENTER CODE” is
displayed.
2. Using the Product buttons, 0-9 enter the code, (1251).
“ENTER CODE **** ” is displayed.
3. Press to enter the Programming Mode.
“PROGRAMMING MODE MENU ITEMS” is displayed.
4. Press two, (2) times. “PROGRAMMING MODE SYSTEM
SETUP” is displayed.
5. Press twelve, (12) times. “START DELAY YES (or NO)” is
displayed.
6. Use and to turn Start Delay on or off.
7. If Start Delay is On (YES), press to display “DELAY TIME
XX:XX”.
8. Use and to set the Delay Time to the desired value.
9. Press to save the changes.
10. Press to return to “PROGRAMMING MODE MENU
ITEMS”
11. Press again to exit.
PROGRAMMING
continued
To Change the Alarm Mode:
1. Press and hold for three, (3) seconds. “ENTER CODE” is
displayed.
2. Using the Product buttons, 0-9 enter the code, (1251).
“ENTER CODE **** ” is displayed.
3. Press to enter the Programming Mode.
“PROGRAMMING MODE MENU ITEMS” is displayed.
4. Press two, (2) times. “PROGRAMMING MODE SYSTEM
SETUP” is displayed.
5. Press thirteen, (13) times. “ALARM MODE AUTO (or
MANUAL)” is displayed.
6. Use and to change the Alarm Mode to either Auto
or Manual.
7. Press to save the changes.
8. Press to return to “PROGRAMMING MODE MENU
ITEMS”
9. Press again to exit.
To Turn Clean Mode On/Off:
1. Press and hold for three, (3) seconds. “ENTER CODE” is
displayed.
2. Using the Product buttons, 0-9 enter the code, (1251).
“ENTER CODE **** ” is displayed.
3. Press to enter the Programming Mode.
“PROGRAMMING MODE MENU ITEMS” is displayed.
4. Press two, (2) times. “PROGRAMMING MODE SYSTEM
SETUP” is displayed.
5. Press fourteen, (14) times. “CLEAN MODE YES (or NO)”
is displayed.
6. Use and to turn Clean Mode On or Off.
7. Press to save the changes.
8. Press to return to “PROGRAMMING MODE MENU
ITEMS”
9. Press again to exit.
To Add a Product Name in Library:
1. Press and hold for three, (3) seconds. “ENTER CODE” is
displayed.
2. Using the Product buttons, 0-9 enter the code, (1251).
“ENTER CODE **** ” is displayed.