Troubleshooting, Introduction, Troubleshooting checklist – Gateway 8450R User Manual
Page 132: Verifying your configuration, Introduction troubleshooting checklist
Introduction
131
7
Troubleshooting
Introduction
If the server does not operate correctly, re-read the instructions for the
procedures you have performed. If an error occurs within a program, refer to
the documentation supplied with the program. This section identifies
solutions to some possible problems.
Troubleshooting checklist
Before turning on the server, make sure that:
■
The power cord is connected to the AC power-in connector and an AC
outlet.
■
The AC outlet is supplying power.
■
If a power strip is used, it is turned on.
■
If the power supply has a voltage selection switch, the voltage selection
switch reflects the proper voltage.
Verifying your configuration
If the server is not operating correctly, the BIOS may contain an invalid
configuration parameter. Open the BIOS Setup utility and check your
configuration settings. (See “About the BIOS Setup utility” on page 111.)
8506284.book Page 131 Thursday, July 13, 2000 11:43 AM