Hot-swapping a power supply module – Gateway 8450R User Manual
Page 84
Power supplies
83
Hot-swapping a power supply module
If all three hot-swap power supply modules are installed, you can replace a
failed module without turning the server off.
To replace a hot-swap power supply module:
1
Follow the static electricity precautions in “Preventing static electricity
discharge” on page 25.
2
Determine which power supply has failed by checking the indicator LEDs
or using your server management software.
3
Remove the bezel. (See “Removing the bezel” on page 27.)
4
Loosen the captive thumbscrew at the bottom of the failed power supply
module.
5
Press down on the tab at the top of the failed module and pull the module
out.
6
Pull the power supply module entirely out of the chassis.
8506284.book Page 83 Thursday, July 13, 2000 11:43 AM