Gateway 8450R - Manual (Page 81)

80 Replacing and Adding Internal Devices
Adding an expansion card
The server supports as many as two 32-bit, 33 MHz PCI expansion cards. These
cards are not hot-swap cards and you must turn off the server before installing
one.
To install an expansion card:
1 Set any jumpers and switches on the replacement card, if required in the
card instructions.
2 Turn off the server, then disconnect the power cord and all external
peripheral devices.
3 Remove the back top panel according to the instructions in “Removing
the back top panel” on page 28. (See “Preventing static electricity
discharge” on page 25.)
4 Remove the EMI foam cover over the processors.
8506284.book Page 80 Thursday, July 13, 2000 11:43 AM