Gateway 8450R - Manual (Page 22)

Starting the server 21
Understanding the Power-On Self-Test
When you turn on your server, the power-on self-test (POST) routine checks
the server memory and components. To see this information on the screen,
press E
SC during POST. Press S PACEBAR to bypass the remaining memory count.
The server displays an error message if POST finds any problems. Write down
any error messages that you see. If you continue to have problems, these error
messages may help you or Gateway technical support diagnose the cause.
Setting up the operating system
The first time you start the server, the operating system takes a few minutes
to set up.
Refer to your operating system documentation for specific questions regarding
the operating system.
To complete the operating system setup:
1 After the server starts, the start-up wizard opens. Click Next .
2 Type the requested information in the appropriate text boxes. When you
have finished typing the information, click
Next .
3 Continue following the instructions and selecting options in the start-up
wizard dialog boxes, clicking
Next to move through the dialog boxes, until
the wizard tells you to restart your server.
If you need to return to the previous dialog box to change any of your
entries, click
Back .
4 Restart the server. The setup is complete.
Important For all operating systems, refer to the appropriate
operating system software manual for specific instructions.
8506284.book Page 21 Thursday, July 13, 2000 11:43 AM