Motorola AP-51XX - Manual (Page 103)

System Configuration 4-11
3. Refer to the Applet Timeout field to set an HTTPS timeout interval.
4. Configure the Secure Shell field to set timeout values to reduce network inactivity.
5. Use the Admin Authentication buttons to specify the authentication server connection
method.
6. Use the Radius Server if a Radius server has been selected as the authentication server.
Enter the required network address information.
SNMP (port 161) Select the LAN1, LAN2 and/or WAN checkboxes to enable access
to the access point configuration settings from an SNMP-capable
client.
HTTP/S Timeout Disables access to the access point if no data activity is detected
over Applet HTTPS (port 443) after the user defined interval.
Default is 0 Mins.
Authentication
Timeout Defines the maximum time (between 30 - 120 seconds) allowed for
SSH authentication to occur before executing a timeout. The
minimum permissible value is 30 seconds.
SSH Keepalive
Interval The SSH Keepalive Interval defines a period (in seconds) after
which if no data has been received from a client, SSH sends a
message through the encrypted channel to request a response from
the client. The default is 0, and no messages will be sent to the
client until a non-zero value is set. Defining a Keepalive interval is
important, otherwise programs running on a server may never
notice if the other end of a connection is rebooted.
Local The access point verifies the authentication connection.
Radius Designates that a Radius server is used in the authentication
credential verification. If using this option, the connected PC is
required to have its Radius credentials verified with an external
Radius server. Additionally, the Radius Server’s Active Directory
should have a valid user configured and have a PAP based Remote
Access Policy configured for Radius Admin Authentication to work.