Motorola AP-51XX - Manual (Page 505)

8-171
AP51xx>admin(system.snmp.access)> add
Description:
Adds SNMP access entries for specific v1v2 and v3 user definitions.
Syntax:
For information on configuring SNMP access settings using the applet (GUI), see Configuring SNMP Access Control on page 4-29 .
add acl <ip1> <ip2> Adds an entry to the SNMP access control list with <ip1> as the starting IP address and <ip2>
and as the ending IP address.
v1v2c <comm> <access> <oid>
: comm - community string 1 to 31 characters
: access - read/write access - (ro,rw)
: oid - string 1 to 127 chars - E.g. 1.3.6.1
v3 <user> <access> <oid> <sec>
<auth> <pass1> <priv> <pass2>
: user - username 1 to 31 characters
: access - read/write access - (ro,rw)
: oid - string 1 to 127 chars - E.g. 1.3.6.1
: sec - security - (none,auth,auth/priv)
: auth - algorithm - (md5,sha1)
: (required only if sec is - auth,auth/priv)
: pass1 - auth password - 8 to 31 chars
: (required only if sec is 'auth,auth/priv')
: priv - algorithm - (des, aes)
: (required only if sec is 'auth/priv')
: pass2 - privacy password - 8 to 31 chars
: (required only if sec is 'auth/priv')
The following parameters must be specified if <sec> is not
none :
Authentication type <auth> set to md5 or sha1
Authentication password <pass1> (8 to 31 chars)
The following parameters must be specified if <sec> is set to auth/priv :
Privacy algorithm set to des or aes
Privacy password <pass2> (8 to 31 chars)