Motorola AP-51XX - Manual (Page 627)

Configuring Mesh Networking 9-39
Resolution
Yes, both the AP-5131 and AP-5181 model access points are identical from a software deployment
standpoint. so it is a supported configuration for AP-5131s and AP-5181s to exist in a single topology.
Mesh Deployment Issue 9 - Can I mesh between and an access point and an AP300?
Can you mesh between a AP-5131, AP-5181 and an AP300 model access port?
Resolution
No, an AP300 does not support mesh networking. so you won't be able to mesh between two AP300s
or between an AP300 and an AP-5131 or AP-5181.
Mesh Deployment Issue 10 - Can I mesh between an AP-5131/AP-5181 and an
AP-4131?
Can I mesh between a newer AP-5131, AP-5181 and a legacy AP-4131 model access point?
Resolution
No, an AP-4131 only supports wireless bridging like Cisco IOS APs. Consequently, an AP-4131 is not
compatible with an AP-5131 or AP-5181 supported mesh deployment.
Mesh Deployment Issue 11 - Can I update firmware/configuration files across a
mesh backhaul?
Can I update device firmware over the mesh backhaul on a client bridge or repeater AP with no wired
connectivity?
Resolution
Yes, both the AP-5131 and AP-5181 support wireless firmware updates.
Mesh Deployment Issue 12 - Can I perform firmware/configuration file updates
with DHCP options?
Can I use the AP’s Automatic Firmware/Configuration update functionalities with DHCP Options on
the AP for mesh nodes as well?
Resolution
Yes, mesh nodes also support Automatic Firmware/Configuration updates using DHCP Options. Make
sure you create DHCP reservations for each mesh node and add an appropriate configuration file to