Motorola AP-51XX User Manual
Page 685
Usage Scenarios
B-19
These three rules should be configured above all other rules (default or user defined). When
Advanced LAN Access is used, certain inbound/outbound rules need to be configured to
control incoming/outgoing packet flow for IPSec to work properly (with Advanced LAN
Access). These rules should be configured first before other rules are configured.
•
Question 13: Do I need to add any special routes on the access point to get my VPN
tunnel to work?
No. However, clients could need extra routing information. Clients on the local LAN side
should either use the access point as their gateway or have a route entry tell them to use
the access point as the gateway to reach the remote subnet.
Dst
<WAN IP address>
Transport
UDP
Scr port
1:65535
Dst port
500
Rev NAT
None