Motorola AP-51XX User Manual

Page 168

Advertising
background image

AP-51xx Access Point Product Reference Guide

5-20

4.

Configure the

PPP over Ethernet

field to enable high speed dial-up connections to the

access point WAN port.

half duplex

Select this option to transmit data to and from the access point, but
not at the same time. Using a half duplex transmission, the access
point can send data over its WAN port then immediately receive
data from the same direction in which the data was transmitted.
Like a full-duplex transmission, a half-duplex transmission can
carry data in both directions, just not at the same time.

full duplex

Select this option to transmit data to and from the access point at
the same time. Using full duplex, the access point can send data
over its WAN port while receiving data as well.

Enable

Use the checkbox to enable Point-to-Point over Ethernet (PPPoE) for
a high-speed connection that supports this protocol. Most DSL
providers are currently using or deploying this protocol.

PPPoE is a data-link protocol for dialup connections. PPPoE allows
a host PC to use a broadband modem (DSL) for access to high-
speed data networks.

Username

Specify a username entered when connecting to the ISP. When the
Internet session begins, the ISP authenticates the username.

Password

Specify a password entered when connecting to the ISP. When the
Internet session starts, the ISP authenticates the password.

PPPoE State

Displays the current connection state of the PPPoE client. When a
PPPoE connection is established, the status displays

Connected.

When no PPPoE connection is active, the status displays

Disconnected

.

Keep-Alive

Select the

Keep-Alive

checkbox to maintain the WAN connection

indefinitely (no timeout interval). Some ISPs terminate inactive
connections. Enabling Keep-Alive keeps the access point’s WAN
connection active, even when there is no traffic. If the ISP drops the
connection after an idle period, the access point automatically re-
establishes the connection to the ISP. Enabling Keep-Alive mode
disables (grays out) the

Idle Time

field.

Advertising