Iomega DataSafe Network Device - Manual (Page 127)

DataSafe NAS User’s Manual 122
8. Use the Type of access drop-down list to
indicate the degree of control the specified client
can exercise over files in the share.
9. Click OK .
To remove an NFS client
1. On the primary menu bar, select Folders and
Shares.
2. On the secondary menu bar, select Windows
and UNIX Shares.
3. From the Object Selection table (Figure 51 on
page 118), select the share for which you want to
add an NFS client or client group.
4. In the Tasks list, click Properties… .
5. On the General tab (Figure 51 on page 118), enter
the Share name , and Share path . Under the
Accessible from the following clients:
prompt, check the Unix (NFS) box.
6. Select the NFS tab.
7. Select the desired client appliance or client group
from the list box in the center, then click
Remove .
8. Click OK .
Related Topics
n
“NFS Service” on page 62
FTP Share Properties
Use this page to specify which FTP clients are granted
access to each share. Access can be granted or denied
on the basis of client host name.
To allow clients permission to an FTP share
1. On the primary menu bar, select Folders and
Shares.