Iomega DataSafe Network Device - Manual (Page 18)

DataSafe NAS User’s Manual 13
Initial DataSafe NAS Configuration
Follow the steps listed below to configure your
DataSafe NAS before first use.
1. Change the DataSafe NAS identity (see
“Identification” on page 17).
2. Change the Administrator password (see “Change
Administrator Password” on page 41).
3. Set the date and time (see “Date and Time” on
page 132).
4. If necessary, change the drive configuration (see
“Configure Disk and Volume Properties” on page
48).
5. Reboot (see “Shutdown Appliance” on page 133).
6. Close your browser session.
For information on other configuration settings, see
the following:
n
Set up local users (“Manage Local Users” on page
93).
n
Set up local groups (“Manage Local Groups” on
page 99).
n
Set up shares and permissions (“Folders and
Shares” on page 106).
Using Help
You can locate information in Help by using any of
the following procedures:
To browse through topics by category