Sanyo KHH2672R / CH2672R - Manual (Page 104)

1
2
3
4
5
6
I-100
SM831148
1. Specifications
Fig. 1-8
Stranded wire
Ring
pressure
terminal
.
ni
8/
3
pir
t
S
Fig. 1-9
Wire
Special
washer
Screw
Ring pressure
terminal
Terminal plate
Screw and
Special washer
Ring
pressure
terminal
Wire
WARNING
Loose wiring may cause the
terminal to overheat or result
in unit malfunction. A fire
hazard may also exist.
Therefore, ensure that all
wiring is tightly connected.
When connecting each power wire to the corresponding
terminal, follow the instructions on “How to connect
wiring to the terminal” and fasten the wire securely with
the fixing screw of the terminal plate.
How to Connect Wiring to the Terminal
For stranded wiring
1) Cut the wire end with a wire cutter or wire-cutting
pliers, then strip the insulation to expose the
stranded wiring about 3/8 in. (Fig. 1-8)
2) Using a Phillips head screwdriver, remove the
terminal screw(s) on the terminal plate.
3) Using a ring connector fastener or pliers, securely
clamp each stripped wire end with a ring pressure
terminal. (Fig. 1-8)
4) Place the ring pressure terminal, and replace and
tighten the removed terminal screw using a screw-
driver. (Fig. 1-9)