Sanyo KHH2672R / CH2672R User Manual
Page 169
1
2
3
4
5
6
V-9
SM831148
5. Outdoor unit maintenance remote control
Setting mode 2
<Operating procedure>
(1) Press and hold the button, button, and button simultaneously for 4
seconds or longer.
(2) Use the temperature setting
and
buttons to change the item code. The
item codes and setting data are shown in the table below.
(3) Use the timer time
and
buttons to change the setting data.
To confirm the changed setting data, press the button.
(At this time, “Setting” stops blinking and remains lit.)
(4) During this mode, “Setting” is displayed, blinking. The display shows the set
outdoor unit address “System XX-YY” (System XX = System address, YY =
Address at outdoor unit sub-bus), item code number (DN value in the table
below), and the setting data (6 digits).
(The setting data is displayed in 6 digits. The display changes between the first 3 digits (Fig.
A
) and the last 3
digits (Fig.
B
). When the first 3 digits are displayed, the top point of the colon is lit.)
(5) To end the setting mode, press the button. The display returns to the normal display mode.
(3)
(1)
(2)
(5)
80: <Refrigerant type> A and B are displayed alternately. (Example shows 000 410 (R410A).)
s
ti
g
i
d
3
t
s
a
l
f
o
y
a
l
p
s
i
D
s
ti
g
i
d
3
t
s
r
if
f
o
y
a
l
p
s
i
D
A
B
(3)
(1)
(2)
(5)