Sun Microsystems Sun Fire V20z - Manual (Page 39)

Chapter 2 Powering On and Configuring the Server 2-15
2.4.7 Quick Boot Feature
The QuickBoot feature, which disables BIOS memory tests, defaults to disabled,
which is the recommended setting.
If you choose to set Quickboot to enabled, you need to perform the following steps
to disable the QuickBoot feature whenever you add new memory, so that the new
memory configuration can be tested.
1. Boot the server and run BIOS Setup by pressing the F2 key during the boot
process.
2. From the Advanced menu, disable the QuickBoot option.
Now the BIOS will run at least one full memory test for your new memory when the
server is rebooted.
3. Press F10 to save the changes and exit.
The system will automatically reboot and run the memory configuration tests.
4. When all memory passes the tests, press the F2 key to enter BIOS Setup and re-
enable the QuickBoot option in the BIOS Advanced menu, if needed.