Sun Microsystems Sun Fire V20z - Manual (Page 57)

Chapter 4 Maintaining the Server 4-5
4.4.1 I/O Board
Follow these steps to remove and replace the I/O board:
1. Turn off the system, including any attached peripherals.
2. While pressing the cover latch release button with your right thumb (A), slide the
cover towards the rear of the chassis until it contacts the stop (B).
3. Lift the cover up and remove it.
FIGURE 4-2 Removing the Cover
4. Remove the two screws securing the I/O board to the motherboard.
FIGURE 4-3 Removing the I/O Board
5. Lift the board straight up to free it from the connector on the motherboard.
Installation is the reverse of this procedure.
Note – When reinstalling the I/O board, ensure that the connector on the I/O board
is seated in the corresponding connector on the motherboard.
Note – Check the routing of all cables for obstructions before reinstalling the cover.
A
B