Sun Microsystems Sun Fire V20z - Manual (Page 59)

Chapter 4 Maintaining the Server 4-7
FIGURE 4-5 PCI Card Slot Cover
4. Remove the card riser assembly from the PCI card connector on the motherboard.
5. Install the PCI card in the riser assembly.
6. Reinstall the riser and card in the connector on the motherboard.
FIGURE 4-6 PCI Card and Riser
7. Pivot the card latch up and then slide it down until it captures the PCI card
bracket. Tighten the screw to secure the latch (refer to Figure 4-5).
Note – Check the routing of all cables for obstructions before reinstalling the cover.
4.4.2.2 To Remove an Existing PCI Card
1. Unfasten all cables connected to the card.
2. Withdraw the card and riser from the PCI card connector on the motherboard.
3. Remove the PCI card from the riser.
Installation is the reverse of this procedure.
Note – If the PCI card is being removed, but not replaced with another card:
Reinstall the empty riser assembly in the empty PCI card connector on the
motherboard. Reinstall the PCI card slot cover.