Sun Microsystems Sun Fire V20z - Manual (Page 60)

4-8 Sun Fire V20z Server User Guide • March 2004
4.4.3 SCSI Hard Disk Drive and Carrier
The following procedure describes how to remove and replace a SCSI hard disk
drive and carrier.
Note – SCSI hard disk drives are hot pluggable in integrated mirroring (IM)
configurations.
To withdraw the SCSI hard disk drive and carrier:
1. Squeeze the release latch and carefully swing the arm to the left as far as it
will go.
FIGURE 4-7 SCSI Hard Disk Drive Carrier and Latch Release
2. Grasp the carrier bezel with both hands and carefully pull the carrier out of the
drive bay.
Note – Avoid using the arm to remove the carrier.
To insert the SCSI hard disk drive and carrier:
1. Squeeze the release latch and carefully swing the arm to the left as far as it
will go
2. Grasping the body of the drive in both hands, carefully guide the connector end
of the SCSI carrier into the drive bay, sliding the carrier into the bay until the arm
engages and partially closes itself.
3. Push the arm forward and latch it to lock the carrier in place.