Sanyo CHDZ09053 - Manual (Page 66)

3-12
Control of W-3WAY ECO-i SYSTEM
1
2
3
4
5
6
7
8
2. Wireless Remote Controller
RCS-XM18AAB.WL for 4Way Air Discharge Semi-
Concealed (XM Type)
2-6. Installing the Receiver Unit
As the receiver can only be installed in the cornerwhere the
panel wire comes out, as shown in Fig. 3-7, consideration
should be given to orientation when fi tting the panel to the
indoor unit.
(1) Twist off the circled area shown in Fig. 3-7 with pliers or
similar.
(2) Remove the suction grille and corner cover. (Fig. 3-8)
(3) Pass the wire from the wireless receiver through the grille.
(Fig. 3-9)
(4) Fit the panel to the indoor unit and connect the wire from
the receiver to the connector (CN130/WL/WHT/10P) on
the indoor control board. (Fig. 3-10)
(5) After fi xing the panel in place, fi t the receiver to the panel
taking care not to trap the wire from the receiver.
(6) Clamp the receiver wire and panel wire together with the
supplied clamper. (Fig. 3-10)
(7) Insert the receiver wire and panel wire into the wire sad-
dles. (Fig. 3-10)
* Refer to the Users Manual supplied with the panel.
NOTE
Do not twist the receiver wire and the power lead-in wire
together as this could lead to malfunction.
If the unit power source is affected by noise, install a noise
filter or take similar measures.
Fig. 3-7
Fig. 3-8
Fig. 3-9
Fig. 3-10