Sanyo CHDZ09053 - Manual (Page 67)

3-13
Control of W-3WAY ECO-i SYSTEM
1
2
3
4
5
6
7
8
Connect the wire from the receiver unit to the CN130 on the indoor PCB.
2-9. Precautions on Simultaneous Installation of Wired Remote Controller
and Wireless Remote Controller
By installing a wired remote controller, the wireless remote controller kit can permit dual
remote control operation at the same time.
(Up to 2 units of remote controllers - a wireless kit and a wired unit - can be installed.)
Dual remote control operation can control 1 or multiple air conditioners using several
remote controllers.
2-7. Accessories
2-8. Wiring the Receiver Unit
Connection diagram
Be sure to determine the correct terminal numbers on
the indoor unit when wiring the remote controller. The
remote controller will be damaged if high voltage (such
as 200 VAC) is applied.
The wireless remote controller kit components cannot
be used for more than 1 indoor unit at a time. (However,
separate receiver units may be used simultaneously.)
When a wireless remote controller kit and a wired re-
mote controller are used simultaneously, assign either
the wireless remote controller or the wired remote
controller as the sub remote controller unit.
CAUTION
2. Wireless Remote Controller