Sanyo CHDZ09053 - Manual (Page 59)

3-5
Control of W-3WAY ECO-i SYSTEM
1
2
3
4
5
6
7
8
2. Wireless Remote Controller
Optional Controller (Remote Controller)
Wireless Remote Controller / RCS-SH80AAB.WL (for X Type) / RCS-TRP80AAB.WL (for A, T Type) / RCS-
BH80AAB.WL (for U, D Type) / RCS - SH1AAB (for K Type) / RCS - XM18AAB.WL
How to Use the Wireless Remote Controller
The illustration above pictures the wireless remote control unit after the cover
has been lowered and removed.
I: FLAP bu tton
Q: Slide switch
L: SET button
P: ACL button
(ALL CLEAR)
A: ON/OFF operation button
B: Transmitter
D: Temperature setting buttons
H: A/C SENSOR button
N: VENTILATION button
J: TIMER SET button
O: Remote control sensor
F: FILTER button
K: Time setting buttons
G: ADDRESS bu tton
E: FAN SPEED selector button
M: CL button
C: MODE button
NOTE
A: ON/OFF operation button This button is for turning the air conditioner on and off.
B: Transmitter When you press the buttons on the wireless remote control unit, the mark appears in the
display to transmit the setting changes to the receiver in the air conditioner.
C: MODE button Use this button to select one of the following five operating modes.
(AUTO) : Used to automatically set cooling or heating operation. Only for single heat pump
type
(Temperature range: 62 ~ 80°F)
(HEAT) : Used for normal heating operation. Only for heat pump type
(Temperature range: 60 ~ 78°F)
(DRY) : Used for dehumidifying without changing the room temperature.
(Temperature range: 64 ~ 86°F)
(COOL) : Used for normal cooling operation.
(Temperature range: 64 ~ 86°F)
(FAN) : Used to run the fan only, without heating or cooling operation.
D: Temperature setting buttons :
: Press this button to increase the temperature setting.
Press this button to decrease the temperature setting.
E: FAN SPEED selector button
(AUTO) : The air conditioner automatically decides the fan speeds.
(HI) : High fan speed
(MED) : Medium fan speed
(LO) : Low fan speed
Continued