Perle Systems 833IS User Manual
833is user guide
Advertising
Table of contents
Document Outline
- 833IS User Guide
- Copyrights
- Important Safety Notice
- FCC/DOC Radio Frequency Interference Statement
- European Community (EC) Mark of Conformity
- INDUSTRY CANADA REQUIREMENTS.
- FEDERAL COMMUNICATIONS COMMISSION (FCC) REQUIREMENTS.
- About this Book
- Users
- How to Use This Guide
- What’s in the Guide
- Contents
- Introduction
- Chapter 1: Quick Installation Overview
- Chapter 2: Site Preparation
- Chapter 3: Setting Up and Installing
- Chapter 4: Using the Perle 833IS Manager
- Chapter 5: Configuring the Perle 833IS
- Chapter 6: Configuring the Interfaces
- Chapter 7: Configuring the Protocols
- Chapter 8: Configuring the User Database
- Chapter 9: Configuring the Server
- Chapter 10: Managing the Perle 833IS
- Appendix 1: Menu Descriptions and Maps
- About Menu Descriptions and Maps
- Front Panel Main Screen
- Front Panel Main Screen Map
- Control
- Control Menu Map
- Status
- Status Menu Map
- Card Status
- Card Status continued
- Card Status continued
- Card Status Menu Map
- Network Status Display
- Network Status Display Menu Map
- Factory Default Mode
- Factory Default Setup
- Factory Default Mode and Setup Map
- Factory Default Mode
- Factory Default Mode Menu Map
- Appendix 2: AT Command Set
- About AT Command Set
- AT Commands
- A/ - Re-execute Command
- AT= x - Write to Selected S-Register
- AT? - Read Selected S-Register
- A - Answer
- Bn - CCITT or Bell
- Cn - Carrier Control
- Dn - Dial
- En - Command Echo
- Hn - Disconnect (Hang-Up)
- Nn - Automode Enable
- On - Return to On- Line Data Mode
- Qn - Quiet Results Codes Control
- Sn - Read/Write S- Register
- Vn - Result Code Form
- Wn - Connect Message Control
- Xn - Extended Result Codes
- AT& Commands
- AT% Commands
- AT\ Commands
- AT+ Commands
- Error Detection and Data Compression Commands
- S-Registers
- S-Register Definitions
- S3 - Carriage Return Character
- S4 - Line Feed Character
- S5 - Backspace Character
- S6 - Wait Time for Dial Tone Before Blind Dialing, or After “W” Dial Modifier (W-Class Models)
- S7 - Wait Time For Carrier After Dial, For Silence, or For Dial Tone After “W” Dial Modifier
- S8 - Pause Time For Dial Delay
- S9 - Carrier Detect Response Time
- S10 - Lost Carrier To Hang Up Delay
- S11 - DTMF Tone Duration
- S36 - LAPM Failure Control
- S46 - Data Compression Control
- S48 - V.42 Negotiation Action
- S86 - Call Failure Reason Code
- AT Command Set Summary
- Appendix 3: Specifications
- Appendix 4: RADIUS Server Attributes
- Appendix 5: Cisco Configuration Mode
- Glossary
- Index
- Numerics
- A
- Access-Accept Messages 280
- Accessing
- Accounting Messages 282
- Account Request Messages 279
- add new Feature Card 72
- Addresses
- Agent ID 178
- Agent Key 177
- AIS 299
- Ambient, Temperature 271
- Analog 206
- ANSI 299
- Assemble
- Asset ID 164, 299
- AssureNet 176
- Async Control 299
- AT% Commands 253, 259
- AT& Commands 251
- AT+ Commands 255
- AT command 299
- AT Commands 241
- ATP 299
- Attach
- Attempts
- AUI 16, 299
- Autonomous Unit Interface see AUI 299
- Axent 176
- B
- C
- Cable
- Cable Requirements 14
- Call 206, 208
- Call Back 146, 183, 300
- Card
- Card Statistics
- CBCP 145, 300
- Central Site 300
- Channel 300
- Channels
- Channel Service Unit see CSU 300
- CHAP 169, 176, 300
- characters, Trigger 168
- Chassis
- Chassis Description 24
- Client Handling 64
- Commands
- Compression 300
- Configuration, Off-line 57
- Configuration File
- Configure 300
- Configuring 75, 120, 122
- Connection
- Connect Time 156
- CRC4 300
- Creating
- CSU 300
- D
- Database 300
- Date and Time
- DB9 30
- Default
- Defaults
- Delay Start 300
- Demarcation Point 19
- Demark Point 300
- DHCP 96, 102, 300
- Dial in
- Dial Modifiers 243
- Dial Out 166
- Digital 300
- Digital Pathways Assurenet 2
- Dimensions 271
- Disabled 300
- Diskette Packet 21
- Display
- Download 69
- DSX-1 300
- DTMF 300
- Dual Tone Multi-Frequency see DTMF 300
- Dynamic 300
- Dynamic Host Configuration Protocol see DHCP 300
- E
- F
- G
- H
- I
- IEEE 301
- Incoming Call Handling 64
- Installation 7
- Installing
- Institute of Electrical and Electronic Engineers see IEEE 301
- Integrated Services Digital Network see ISDN 301
- Interface 203
- Internet Packet eXchange see IPX 301
- Internet Protocol see IP 301
- IP 45
- IP Filter Definition 110
- IP RIP, Display contents 211
- IPX 45, 114
- IPX FIlter 160
- IPX RIP
- ISDN 204
- L
- M
- MAC 301
- Main Screen
- Main screen 51
- Manager
- Manager software
- MAU 37, 48, 301
- Media Access Code see MAC 301
- Menu
- Menu Bar 52
- Menu Descriptions
- Microsoft
- Mode
- Modem 207
- Modem Initialization String 301
- Modems
- MODulate/DEMmodulate see Modem 301
- MTBF 271
- MTTR 271
- multicast 302
- multiplexing 302, 303
- Multistation Access Unit see MAU 301
- N
- O
- P
- Packet 302
- PAP 169, 176, 302
- Password
- PBX 302
- PC requirements 44
- Perle 833IS
- Placement, Unit 13
- Point to Point Protocol see PPP 302
- ports
- Power
- Power Cord 7, 27
- Power Switch 27
- PPP 129, 302
- PRI 80, 130, 302
- Primary Rate Interface see PRI 302
- Print 52
- Private Branch eXchange see PBX 302
- Protocol 302
- Protocols
- Protocol Stack 302
- Q
- R
- Rack Mount 302
- Radius 2, 96, 173, 302
- RADIUS Server Attributes 279
- RARP 39, 302
- Recent File List 53
- Reduced Instruction Set Computer
- Relative Humidity 13, 271
- Remote Authentication Dial In Users Services see Radius 302
- Remote Node 63, 302
- Removing
- Request for Comment see RFC 302
- Requirements
- Reverse Address Resolution Protocol
- RFC 189, 302
- RIP 302
- RISC 303
- RJ11 303
- RJ-45 14, 303
- RJ-48C 19, 303
- Roaming Call Back 303
- Router 303
- Routing Information Protocol see RIP 302
- S
- SAP 40, 117, 214
- Save 52
- Save As 52
- SecurID 2, 179, 303
- Security 2, 169
- Security Screen
- Serial Number label 27
- Server 163, 200–??
- Server List 49
- Service Advertising Protocol see SAP 303
- Setting, Date and Time 74
- Setup
- Shared User Database 160
- Shielded Twisted Pair see STP 303
- Simple Network Management Protocol
- Simple Network Management Protocol see SNMP 303
- SNAP 115, 212
- SNMP 169, 303
- Sockets 122, 303
- Speed
- S-Register Definitions 263
- S-Registers 261
- Standard Profile 303
- Start
- Static Route Services 122
- Statistics
- Status 205– 206, ??– 208
- Status Bar 51
- STP 30, 303
- Subnet mask 303
- Subnetwork Access Protocol see SNAP 303
- Support 303
- Switch
- System
- System Requirements 44
- T
- U
- V
- W