Draft, Nokia m10 user’s manual – Nokia M10 User Manual

Page 105

Advertising
background image

Nokia M10 User’s Manual

DRAFT

E

Copyright Nokia Telecommunications Oy

NTC C33539002SE_A0

5-56

Command

Set default gateway IP address

Description

Specifies the IP address of the default IP gateway. Only
applies when the default gateway interface is

ip-ad-

dress

.

Syntax

set ip gateway default [ip_address]

Arguments

ip_address

argument is the IP address of the default

gateway.

Example

m10> set ip gateway default 191.233.22.1

Command

Enable IP packet forwarding and route distribution
between ATM VCC interfaces

Description

Enable/disable IP packet forwarding and route distribu-
tion between ATM VCC interfaces. If only one VCC is
used this option can be ignored.

Syntax

set ip interwan-routing [on|off]

Arguments

The argument enables/disables interwan routing.

Example

m10> set ip interwan-routing on

Use the following commands to configure settings for routing IP over
PPP link.

Command

Enable/disable routing IP over PPP link

Description

Enables/disables IP routing through the specified logi-
cal ATM channel using ppp-vcmux encapsulation.

Syntax

set ip ip-ppp {vccx} option [on|off]

Arguments

The first argument identifies the ATM channel (vccx, x =
1 ... 8). If there is only one ATM channel using ppp-
vcmux encapsulation you can leave the argument

vccx

out. The on/off argument enables/disables routing.

Example

m10> set ip ip-ppp vcc1 option off

Note

You must enable IP routing before you can enter other
IP routing settings for the serial port. If you turn off IP
routing and save the new configuration, the Nokia
M10 clears IP routing settings.

Advertising
This manual is related to the following products: