Nokia M10 - Manual (Page 32)

Nokia M10 User’s Manual
DRAFT
E Copyright Nokia Telecommunications Oy NTC C33539002SE_A0 4-8
Here the configuration is done using the command line interface (CLI)
through the console port of Nokia M10. A special cable is needed, type
designation E64320.01.
Step 1: Connect cables
D Connect the mains power cord to your M10 and the other end to the
power outlet.
D Connect the M10 console cable to the console port behind the
hatch in the front panel of your M10. Connect the other end of the
cable to the serial port of your PC/terminal.
OK EXIT
DNT2M
DSR DCD RTS CTS
1 8
Node Manager Connector
(RJĆ45)
1. 107 (Const. ON)
2. 108 (IN)
3. 109 (OUT)
4. SG
5. 103 (IN)
6. 104 (OUT)
7. 105 (IN)
8. 106 (OUT)
Figure 4-3 Location of the console port
D Turn on your Nokia M10. The green status indicator and the red
DSL indicator light up.
Step 2: Turn on your PC and start the terminal software
Set the following terminal software parameters: 9600, 8 bits, no parity,
1 stop bit, no flow control.
Press enter in the terminal window. The Nokia command line interface
prompt will be displayed.
Step 3: Configure the M10
The configurations given here assume that the unit uses its default
configurations and the changes are done on top of the default
configuration.