Nokia M10 - Manual (Page 115)

Nokia M10 User’s Manual
DRAFT
E Copyright Nokia Telecommunications Oy NTC C33539002SE_A0 5-66
Command Set netmask to channels using PPP over ATM en-
capsulation in bridged mode
Description Assigns an IP network mask to the specified logical
ATM channel using ppp over ATM encapsulation in
bridged mode.
Syntax set ip wan {vccx} netmask [netmask]
Arguments The first argument identifies the ATM channel (vccx, x =
1 ... 8). If there is only one ATM channel using ppp-
vcmux encapsulation you can leave the argument
vccx
out. The second argument is the netmask address to
be assigned to that channel. If you enter 0.0.0.0 as the
netmask Nokia M10 will retrieve the netmask through
the remote peer using Dynamic Host Configuration Pro-
tocol.
Example m10> set ip wan vcc2 netmask 0.0.0.0
Command Enable/disable address mapping on channels
using PPP over ATM encapsulation in bridged
mode
Description Specifies whether you want the Nokia M10 to use
NAPT on the specified ATM link using PPP over ATM
encapsulation in bridged mode (BNCP option on) when
communicating with remote routers. Address mapping
lets you hide details of your network from remote
routers. This is useful when connecting to an Internet
Service Provider.
Syntax set ip wan {vccx} addr-mapping [on|off]
Arguments The first argument identifies the ATM channel (vccx, x =
1 ... 8). If there is only one ATM channel using ppp-
vcmux encapsulation you can leave the argument
vccx
out. The second argument is enables/disables address
mapping.
Example m10> set ip wan vcc2 addr-mapping off