Nokia M10 - Manual (Page 114)

Management
DRAFT
E Copyright Nokia Telecommunications Oy NTC C33539002SE_A0 5-65
Command Set IP address to channels using PPP over ATM en-
capsulation in bridged mode
Description Assigns an IP address to the specified logical ATM
channel using PPP over ATM encapsulation in bridged
mode (BNCP option on).
Syntax set ip wan {vccx} address [ip_address]
Arguments The first argument identifies the ATM channel (vccx, x =
1 ... 8). If there is only one ATM channel using ppp-
vcmux encapsulation you can leave the argument
vccx
out. The second argument is the IP address to be as-
signed to that channel. If you enter 0.0.0.0 as the net-
work mask Nokia M10 will retrieve the IP address
through the remote peer using Dynamic Host Configur-
ation Protocol.
Example m10> set ip wan vcc2 address 0.0.0.0
Command Set broadcast address to channels using PPP over
ATM encapsulation in bridged mode
Description Assigns a broadcast IP address to the specified logical
ATM channel using PPP over ATM encapsulation in
bridged mode (BNCP option on).
Syntax set ip wan {vccx} broadcast [broadcast_address]
Arguments The first argument identifies the ATM channel (vccx, x =
1 ... 8). If there is only one ATM channel using ppp-
vcmux encapsulation you can leave the argument
vccx
out. The second argument is the broadcast address to
be assigned to that channel. If you enter 0.0.0.0 as the
broadcast address Nokia M10 will retrieve the IP ad-
dress through the remote peer using Dynamic Host
Configuration Protocol.
Example m10> set ip wan vcc2 broadcast 0.0.0.0