Nokia M10 - Manual (Page 25)

Installation
DRAFT
E Copyright Nokia Telecommunications Oy NTC C33539002SE_A0 4-1
Chapter 4
Installation
This chapter presents a step-by-step installation example procedure
for three different application examples of Nokia M10:
D Internet access (NAPT router)
D Remote work (basic router)
D LAN interconnection (basic bridge)
These installation procedures are examples to guide you through some
of the typical use cases.
The installation examples assume that you have a new M10 with a
factory default configuration. The complete default configuration is
presented in the end of this chapter. The default settings are, briefly:
D Single ADSL/ATM channel (VPI = 0, VCI = 100)
D PPP over ATM/AAL5 encapsulation
D M10 retrieves IP address configuration from the IP network using
PPP-IPCP negotiation
D Network Address Port Translation activated
D Private IP addresses in use in LAN
D DHCP server for the LAN interface activated
Before starting the installation, unpack the unit and check that it is
physically undamaged.
4.1 Internet access (NAPT router)
This application is based on the default configuration of the Nokia
M10. By default, Nokia M10 is an Internet access device that uses