Nokia M10 - Manual (Page 64)

Management
DRAFT
E Copyright Nokia Telecommunications Oy NTC C33539002SE_A0 5-15
Other encapsulations
Figure 5-10 ATM channel configuration page (other encaps.)
1. Set the virtual path and virtual channel identifications.
2. Enable/disable IP.
IP settings allows you to activate the IP layer function of the ATM
channel. Local address, netmask and broadcast address specify
the basic IP address parameters of the ATM channel interface (IP
over RFC1483). If you enter 0.0.0.0 to these fields the M10 will try
to get them from the network either using IPCP protocol (ATM
channel using PPP) or DHCP (ATM channel not using PPP).
Address mapping radio button activates/deactivates the Network
Address Port Translation (NAPT).