Nokia M10 - Manual (Page 113)

Nokia M10 User’s Manual
DRAFT
E Copyright Nokia Telecommunications Oy NTC C33539002SE_A0 5-64
Command Flush routes
Description Enabled flush routes function deletes the learned
routes from the routing table when the PPP connection
is disconnected. Address mapping must be off.
Syntax flush-routes [on|off]
Arguments The argument enables/disables flush routes function.
Example m10> flush-routes on
Command Enable/disable the management through channels
using IP over ATM or bridged encapsulations
Description Enables/disables the management of Nokia M10
through the specified ATM link using ip-llc, ip-vcmux,
ether-llc, or ether-vcmux encapsulation.
Syntax set ip dsl {vccx} admin-disable [on|off]
Arguments The first argument identifies the ATM channel (vccx, x =
1 ... 8). If there is only one ATM channel using one of
these encapsulations you can leave the argument
vccx out. The second argument disables/enables man-
agement through the PPP link.
Example m10> set ip dsl vcc2 admin-disable off
Command Enable/disable IP routing on ATM channel
Description Enables/disables IP routing on the specified ATM chan-
nel using PPP over ATM encapsulation in bridged
mode (BNCP option on).
Syntax set ip wan {vccx} option [on|off]
Arguments The first argument identifies the ATM channel (vccx, x =
1 ... 8). If there is only one ATM channel using ppp-
vcmux encapsulation you can leave the argument
vccx
out. The second argument enables/disables the func-
tion.
Example m10> set ip wan vcc2 option off