Nokia M10 - Manual (Page 109)

Nokia M10 User’s Manual
DRAFT
E Copyright Nokia Telecommunications Oy NTC C33539002SE_A0 5-60
Command Enable/disable IP routing on channels using IP
over ATM or bridged encapsulations
Description Enables/disables IP routing on the specified ATM chan-
nel using the IP over ATM encapsulations (ip-llc, ip-
vcmux) or bridged encapsulations (ether-llc, ether-
vcmux).
Syntax set ip dsl {vccx} option [on|off]
Arguments The first argument identifies the ATM channel and the
second argument enables/disables IP routing. If there
is only one ATM channel using one of these encapsula-
tions you can leave the argument
vccx out.
Example set ip dsl vcc2 option off
Command Set IP address to channels using IP over ATM or
bridged encapsulations
Description Assigns an IP address to the specified logical ATM
channel using ip-llc, ip-vcmux, ether-llc, or ether-vcmux
encapsulation.
Syntax set ip dsl {vccx} address [ip_address]
Arguments The first argument identifies the ATM channel (vccx, x =
1 ... 8). The second argument is the IP address of that
channel. If there is only one ATM channel using one of
these encapsulations you can leave the argument
vccx out. If you enter 0.0.0.0 as the IP address Nokia
M10 will retrieve the IP address through the remote
peer using Dynamic Host Configuration Protocol.
Example m10> set ip dsl vcc2 address 0.0.0.0