Nokia M10 - Manual (Page 77)

Nokia M10 User’s Manual
DRAFT
E Copyright Nokia Telecommunications Oy NTC C33539002SE_A0 5-28
Command Define log level
Description Displays or modifies the types of log messages you
want the Nokia M10 to record. You can enter the logle-
vel command with the
level argument to specify the
types of diagnostic messages you want to record. All
messages with a level number equal to or greater than
the level you specify are recorded.
Syntax loglevel {level}
Arguments If you enter the loglevel command without the op-
tional level argument, the Nokia CLI displays the cur-
rent log level setting. The values for the argument are:
1 or low
Trivial status messages.
2 or medium Messages that can help
monitor the network traffic.
3 or high Status messages that may be
significant but do not
constitute errors.
4 or warning Recoverable error conditions
and useful operator
information
5 or failure Messages describing error
conditions that may not be
recoverable
Example M10> loglevel 3
Command Ping
Description Causes the Nokia M10 to issue a series of ICMP Echo
requests for the device with the specified IP address.
You can use the
ping command to determine whether
an IP address is already in use on your network. You
cannot use the ping command to ping the Nokia M10’s
own IP address. If a host using the specified IP address
is active, it returns one or more ICMP Echo replies,
confirming that it is accessible from your network.
Syntax ping [ip_address]
Arguments ip_address argument is the IP address, in dotted
decimal notation, of the device you want to locate.
Example M10> ping 192.122.12.11